Source and learning scope

Source: An Introduction to GNSS and Beyond: GPS, GLONASS, BeiDou, Galileo and the Increased Accuracy of Correction Services, first edition, Veripos Limited, 2020, ISBN 978-0-9813754-0-3. The reviewed front matter names the publisher but no individual book author. This lesson is original educational commentary based on the first 50 PDF pages reviewed, covering GNSS fundamentals, signal errors, differential methods, SBAS and the start of RTK. Later chapters were not reviewed; the PPP comparison below is supported separately by official NovAtel material.

The book is a dated manufacturer publication, not a vessel operating manual or a present-day service specification. Its constellation counts, deployment forecasts, product descriptions and example error ranges must not be treated as current operational guarantees. The copyrighted PDF and its illustrations are not redistributed. Publisher resources are linked below.

Learning aim: understand what sits behind a GNSS position on the DP desk, and recognise why a precise-looking number is not enough to establish a safe position reference.

How GNSS finds a position

GNSS is the family of satellite navigation systems, including GPS, GLONASS, Galileo and BeiDou. GPS is one constellation, not a synonym for all GNSS.

A receiver uses the satellite orbit information and signal timing to estimate ranges. A code observation is a pseudorange: it includes clock offsets and other errors, rather than being a perfect geometric distance. In a basic single-constellation three-dimensional solution, at least four suitable satellite observations are needed to solve for three position coordinates and receiver clock bias. Multi-constellation processing can introduce additional time-offset unknowns; the receiver implementation and available observations matter. Four satellites are not a DP acceptance criterion.

Carrier-phase observations can support more precise positioning, but contain ambiguity terms that must be resolved or estimated. Fine measurement precision is not the same as a correct, trustworthy vessel position.

Original diagram showing satellite observations and correction data feeding a vessel GNSS receiver, quality checks and the DP estimator, with a diverse reference for comparison.

Original conceptual diagram, not a specific VERIPOS installation drawing. The appropriate diverse reference depends on the vessel and activity.

Accuracy, geometry and integrity are different

TermMeaning for the watchkeeperWhat it does not prove
AccuracyCloseness to the true position, under stated conditions and confidence definitionA small displayed uncertainty is not external proof of the true position.
PrecisionRepeatability or fine resolution of measurements/solutionsA stable solution can still be biased.
DOPDilution of precision: how satellite geometry magnifies measurement uncertaintyLow DOP does not certify freedom from multipath, interference, spoofing or wrong configuration.
IntegrityAbility to detect or indicate when the information cannot be relied on within the relevant limitsAn accuracy claim alone does not establish suitable integrity monitoring.
Availability and continuityWhether a usable service exists and remains usable over the operationA working link now does not guarantee uninterrupted future service.

Satellites spread across the usable sky generally provide better geometry than a tight cluster. More constellations can improve the opportunity to obtain useful geometry, but satellite count alone does not establish quality. Do not invent a universal DOP threshold; use the vessel-approved criteria and equipment guidance.

Errors that matter offshore

Error or disturbancePractical effectWatchkeeping implication
Satellite clock and orbit errorsRange and computed-position errorsCorrection services can reduce particular errors, subject to the method and data validity.
IonosphereFrequency-dependent delay; activity can vary with place and timeMulti-frequency processing helps mitigate delay, but is not immunity from severe disturbances.
TroposphereDelay influenced by atmospheric conditionsModels and suitable differential techniques reduce effects; residual errors remain.
MultipathReflections from steel structures, platforms or nearby vessels distort observationsRemote correction data cannot simply remove a local reflection at the antenna. Antenna siting and equipment performance matter.
ObstructionCranes, structures or adjacent vessels block parts of the skyGeometry and solution availability may deteriorate as heading or the worksite changes.
Interference and spoofingSignals may be denied or misleadingPlausible output or agreement between two GNSS sets is not proof of independence or correctness.
Antenna, cable or configuration faultsDegraded observations or a systematic output errorVerify installation, datum, offsets, time and output configuration through controlled procedures.

The book gives illustrative error values for its era. They are not used here as a present-day error budget or a safe operating envelope.

Correction methods: DGNSS, SBAS, RTK and PPP

MethodBasic approachDependencies to understand
DGNSSReference receivers at known positions derive differential corrections; a user applies compatible dataReference quality, common observations, correction age, delivery and geographic separation influence performance.
SBASA regional monitoring network broadcasts augmentation information through satellitesCoverage, supported signals, service definition and receiver capability matter. Aviation service claims do not automatically certify a marine DP application.
RTKCarrier-phase processing uses nearby reference-station or network observations, with ambiguity handlingBaseline/network conditions, reference coordinates, communications and fixed/float solution status matter. No universal baseline limit is supplied here.
PPPPrecise satellite corrections from a wide-area network are used in the user receiver’s positioning modelService availability, supported equipment/signals, convergence or reconvergence, correction validity and local observations matter. No nearby user base station is normally required for conventional PPP.

The categories are a teaching comparison, not interchangeable approvals. Commercial systems may use enhanced or hybrid methods. Verify the current service specification and the actual installed configuration; no accuracy, convergence time, licence capability or coverage promise is inferred from a VERIPOS brand name or a 2020 product listing.

A receiver can still output coordinates after correction loss. That does not mean the accepted accuracy or operating mode has been retained. Conversely, the response to a short outage is product- and configuration-specific: check alarms, mode, validity and the approved procedure rather than assuming every system instantly behaves the same way.

From antenna position to the DP reference point

The antenna is not necessarily at the vessel control point. The system must account for the surveyed antenna offset and the approved reference frame. As the vessel turns, a body-fixed offset must be transformed using the vessel attitude/heading information; this is why offset configuration and sensor quality matter.

Check the datum, units, coordinate frame, reference point and timestamp as well as the numerical position. A delayed but apparently smooth position can be inappropriate for the control loop. Do not change offsets, datum or filtering settings during work as an improvised cure for disagreement.

The DP estimator may combine GNSS with heading, motion and other position references. Kalman-style filtering can reduce noise and bridge limited measurement interruptions within its design, but it cannot turn an unrecognised shared bias into a true position. A smooth prediction is not independent confirmation.

Two GNSS receivers are not automatically independent

Receiver duplication can protect against some equipment failures. It does not necessarily protect against a shared antenna arrangement, power source, correction dependency, blocked sky, local interference or a misleading signal environment.

This common-mode warning is engineering reasoning based on shared dependencies and multi-source PNT principles—not a claim that every twin-GNSS installation is non-compliant. Independence must be demonstrated for the vessel’s approved arrangement, FMEA and operating configuration. A suitable laser, hydroacoustic or other diverse reference may provide an additional comparison where fitted and applicable; each has its own failure modes and limits.

Agreement is evidence to assess, not a verdict. Two outputs may agree because both are healthy, or because both share the same error. Investigate disagreement and suspicious agreement in the full operational context.

DP watchkeeping: questions before accepting a reference

  • Is the receiver in the intended solution mode, with valid status and alarms understood?
  • Are observations and correction data sufficiently current under the approved criteria, and is the expected delivery path healthy?
  • Have uncertainty, geometry, satellite visibility or signal quality changed with vessel heading, cranes or nearby structures?
  • Are the datum, antenna offsets, reference point and timing configuration accepted and unchanged?
  • Do suitably independent references and vessel motion information support the position, after accounting for their own offsets and limitations?
  • Does the present reference combination satisfy the activity-specific operating guidelines (ASOG/WSOG) and vessel procedures?
  • If quality deteriorates, who must be informed, and what approved suspend/abort or safe-state response applies?

Do not use this list to create generic alarm limits or override the DP system. A DPO should follow the approved operating response, record the event and coordinate with the relevant team.

Real-condition examples

SituationSound interpretation
Position quality worsens beside a steel platform after a heading changeConsider obstruction, multipath and geometry alongside equipment status; do not assume the correction provider alone is at fault.
Both GNSS references shift together while a diverse reference and motion information disagreeConsider common-mode faults, offsets, timestamps and the diverse reference’s limits; follow the approved response rather than accepting a majority vote.
The correction link is lost but coordinates remain visibleCheck the actual solution mode, uncertainty, data age and approved operating limits. Displayed coordinates alone do not establish suitability.
An RTK solution changes from fixed to floatTreat the solution-state change as relevant information; assess fitness against approved criteria rather than promising either safety or failure from the label alone.
A PPP service restarts after an interruptionVerify the installed system’s reconvergence and acceptance status; do not assume earlier performance is instantly restored.

Self-test

  1. Is GPS the same as GNSS?

Answer 1

No. GPS is one satellite constellation; GNSS is the broader family that also includes GLONASS, Galileo, BeiDou and others.

  1. Why does a basic single-constellation 3D solution need at least four suitable observations?

Answer 2

It solves three position coordinates and receiver clock bias. This mathematical minimum is not a DP reference acceptance criterion.

  1. Does a low DOP prove that a position is trustworthy?

Answer 3

No. DOP describes geometric amplification of measurement uncertainty, not immunity from local errors, interference, spoofing or wrong configuration.

  1. What is the main conceptual difference between conventional RTK and PPP?

Answer 4

RTK uses local or network reference observations and relative carrier-phase processing; PPP uses precise satellite corrections from a wide-area network in the user solution. Both have method-specific dependencies.

  1. Can a remote correction service guarantee removal of local multipath?

Answer 5

No. Reflections at the vessel antenna are local measurement effects. Antenna siting, receiver/antenna performance and operational checks remain important.

  1. Why can two GNSS receivers agree on a wrong position?

Answer 6

They may share an error source such as misleading signals, local interference, correction dependencies or configuration. Receiver count alone does not demonstrate independence.

  1. What must be considered when using an antenna position as a vessel DP reference?

Answer 7

The surveyed offset, coordinate frame/datum, approved reference point, heading/attitude transformation, timestamp and latency must be correctly handled and accepted.

  1. Does continued coordinate output after correction loss prove a reference remains suitable?

Answer 8

No. Check the actual mode, validity, correction age, uncertainty and approved operating criteria, then follow the vessel’s ASOG/WSOG and procedures.

Sources and further reading

Original lesson prepared 7 November 2026. Use current manufacturer documentation and the vessel’s approved operating guidance for actual work.

Related lessons and guides